BED - Roller bed with 1.9 in. dia. roller x 16 ga. galvanized tube spaced every 3 in. Mounted in 9-1/2 in. x 12 ga. powder painted formed steel channel frame bolted together with splice plates.
CROSS BRACING - Rods with turnbuckles are fastened to underside of bed to provide proper alignment of bed rollers and insure correct product tracking. Supplied on every other section 30 ft. bed lengths and over.
DRIVE - Mounted underneath, placed near center of conveyor. NOTE: On Conveyors less than 24 in. OAW motor extends beyond frame. Chain guard located on left hand side.
DRIVE SHAFT - 1 in. dia. steel shaft extends full length of conveyor. Chain coupling at bed joints. Located on left hand side.
DRIVE SPOOLS - 2 in. dia. Delrin spool held in place on drive shaft with spool spacers.
DRIVE GUARD - Underside of drive shaft with spools and drive o-rings guarded full length of conveyor.
DRIVE O-RING - 3/16 in. dia. polyurethane o-ring from drive spool to tread rollers.
BEARINGS - Sealed, pre-lubricated, self-aligning, ball bearings with eccentric lock collar on drive shaft. Pre-lubricated ball bearings in tread rollers.